I ran across post on CiscoBlog.com about the configure replace command. I had not ever seen this command before, but I could have used it quite a few times in the past. Essentially it will let you replace the running config with another config instead of the standard copy command which just merges the two configs.
Below is the link for more information on Cisco's website
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tcf_r/cf_02ht.htm#wp1031947
This command was first introduced in 12.3(7)T
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment